Network Based Installation Guide – Home

Admin Installation

1. Run “Setup” from the installation folder (As was done for the Server installation).
2. At the “Customer Information” screen, change the” Installation Type” field field to reflect “Admin”.

3. Continue the installation in the same fashion as the Server setup, accepting all the defaults.
4. Finally , the screen below will appear after the installation has completed.

6. Press the F10 key on the keyboard.

7. As indicated in the image, the Admin module would not have automatically connected to the Dserver.
8. Click on “Options”

9. The following screen is then presented:

10. Now press the F3 key on the keyboard
11. The following screen is then presented:

12. Enter the host-name of the Server pc in the “Server Name” field and press <Enter>.
13. Press <esc> several times, until back at the Main Screen
14. Press F10 on the keyboard. The Socket Status should now indicate:”Connected”

15. Should the “Socket State” NOT indicate “Connected”, refer to “Connection Problems” in the last post.
16. Press <esc> several tymes to close the program.
17. There should now be two new icons on the Desktop, Network Admin and User Admin:

18. 18. Double-click the Network Admin icon.
    19. The following screen should appear:

18. 18. 19. Enter the password “roTide” and click OK.
        20. The next screen is presented:

<

18. 18. 21. The Institution Name may be changed by clicking on that space and entering the desired name.

---

Network Based Installation Guide – Home